This sheet carries fifteen chicken and rooster decals printed in a warm copper metallic finish. The designs span a lively range of barnyard poses: roosters standing upright with full tail plumage fanned out, hens stepping forward in profile, birds caught mid-motion with wings partially spread, a large decorative bird with an elaborate feathered display, and pairs of birds in animated stances. The illustrations are rendered in fine-line detail, capturing individual feathers, combs, wattles, and scaled legs in a style that recalls vintage folk-art engravings. Against the pale backing, the copper tone reads warmly and will catch light once fired onto glass.
These are water-slide transfers fired onto the surface of pre-fired glass pieces. Because the decal is applied after the glass has already been fused and does not function as a compatible glass layer, they work with any COE glass without compatibility concerns. To apply, trim individual decals apart with scissors if needed, soak in clean water for 20 to 30 seconds until the image slides freely from its backing paper, position it on thoroughly clean glass, smooth out water and air with a soft squeegee or damp brush, and allow the piece to dry fully before firing.
How many decals are on this sheet?
The sheet holds fifteen individual chicken and rooster decals. You can use them one at a time by trimming them apart before soaking.
What glass can I use these on?
These decals are applied to the surface of already-fired glass, not layered into a fuse, so no COE compatibility matching between the decal and the base glass is required. They can be fired onto pieces made from any COE glass.
Is the copper color a metallic finish?
Yes. The decals carry a warm copper metallic finish, as visible in the product image. This is a single-color sheet, so fire it toward the lower end of its range to keep the copper dense, as noted in the firing schedule below.
Can I place these on curved or slumped pieces?
Yes, as long as the glass was pre-fired before you apply the decal. Apply the decal to the cooled, fired piece, let it dry, then re-fire according to the schedule below. The decal fires onto the surface regardless of the form of the glass.
Specifications
- SKU: 159257
- Sold as a printed water-slide decal sheet
- Decal count: 15 chicken and rooster designs in copper metallic
- Firing range: 1240 to 1370 degrees F
- Fires onto pre-fired glass of any COE
- Sheet size: 5.25 x 4 inches
Working Notes
Clean the glass surface thoroughly before applying any decal. Oils, fingerprints, or kiln wash residue can prevent the decal from adhering smoothly and may cause lifting or bubbling during firing. After soaking and positioning the decal, use a soft rubber squeegee or a damp flat brush to work out all trapped water and air from the center outward. Allow the piece to dry completely at room temperature before ramping to firing temperatures. Do not fire a wet piece.
Suggested Firing Schedule (a starting point only, not a guarantee of results): This is a single-color decal, so fire toward the lower end of its range to keep the image dense. Ventilate the kiln well up to 1000 degrees F and fire slowly below 500 degrees F. Every kiln fires differently, so test a small piece first and anneal for the thickness of your glass.
50 degrees per hour to 185 degrees F, hold 20 min.
150 degrees per hour to 300 degrees F, hold 15 min.
250 degrees per hour to 500 degrees F, hold 15 min.
600 degrees per hour to 1000 degrees F, hold 10 min.
Then to 1240 to 1370 degrees F, hold about 10 min.
Anneal for the thickness of your glass.
Description updated: July 6, 2026
Spot an error or have feedback on this description? Report it here.