Large Circles 2 Decal Sheet

This decal sheet carries twelve circles, each filled with a different geometric pattern, all printed in deep navy blue on a clear film. The designs include tight comma-style swirls, mesh globe grids, concentric dashed rings, coiled spirals, spoke-and-tick target circles, and radiating sunburst spikes. With twelve distinct fills on one sheet, you can build contrast and variety within a single fused piece or spread the motifs across a series.

These are water-slide fusible glass decals applied to clean, pre-fired glass and then kiln-fired. Because the decal bonds to the glass surface rather than fusing as a compatible glass layer, the sheet works with glass of any COE. Once fired, the design becomes a permanent part of the surface, adding graphic pattern to fused tiles, plates, jewelry, and other kilnformed work.

How do I apply a water-slide decal from this sheet?
Cut the decal away from the sheet and soak it in clean, room-temperature water for 30 to 60 seconds until it slides freely from its backing paper. Slide it into position on clean, dry, pre-fired glass, then smooth water and air outward from the center with a soft squeegee or fingertip. Let the piece dry completely before firing.

Do these decals work with the COE glass I already have?
Yes. Because the decal fires onto the surface of pre-fired glass rather than fusing as a compatible glass layer, no COE matching is needed. Clean, fully pre-fired glass of any COE accepts these decals.

Can I use several different patterns together in one piece?
Yes. Each of the twelve decals has a different geometric fill, including swirls, mesh grids, concentric rings, spirals, and sunbursts, so you can mix and match freely. Every decal is applied and fired the same way regardless of which pattern you choose.

Specifications

• SKU: 153532
• Sheet size: 4 x 5.25 inches
• Sold as a single printed decal sheet
• Decals per sheet: 12 navy blue circles
• Firing range: 1240 to 1370 degrees
• Works with any COE glass

Working Notes

Apply decals only to clean, dry, pre-fired glass. Soak each decal briefly in clean water, slide it into position, smooth out bubbles gently, and let the piece dry completely before firing. These navy patterns fire in the single-color decal range, roughly 1240 to 1370 degrees, kept toward the lower end to preserve density.

Suggested Firing Schedule (a starting point only, not a guarantee of results; every kiln fires differently, so test a small piece first and anneal for the thickness of your glass): Ventilate the kiln well up to 1000 degrees and fire slowly below 500 degrees. Ramp 50 degrees per hour to 185 degrees, hold 20 minutes. Ramp 150 degrees per hour to 300 degrees, hold 15 minutes. Ramp 250 degrees per hour to 500 degrees, hold 15 minutes. Ramp 600 degrees per hour to 1000 degrees, hold 10 minutes. Then ramp to a final 1240 to 1370 degrees, held about 10 minutes, staying toward the lower end to preserve density. Anneal for the thickness of your glass.

Description updated: July 6, 2026

Spot an error or have feedback on this description? Report it here.