The Mandala Textured Fusing Tile from Creative Paradise is a ceramic kiln tile used on the kiln shelf beneath glass during fusing. As the glass heats and softens, it picks up the mandala relief from the tile surface, leaving a textured pattern on the underside of the finished piece. The tile measures 7 inches by 7 inches, with a diagonal of 10 inches.
Frit may also be fused directly on the tile surface to create a dramatic mandala-patterned piece. Like all Creative Paradise ceramic kiln accessories, this tile is COE agnostic and reusable across many firings when properly prepared between uses.
What does the Mandala Textured Fusing Tile do?
It imprints a mandala texture onto the underside of glass fused on top of it. You can also fuse frit directly on the tile surface to produce a freestanding patterned glass piece.
How do I set up the tile for a fusing session?
Apply a glass separator or kiln wash to the tile surface and let it cure completely. Place your glass sheet or layers on top of the prepared tile, then fire using a schedule suited to your glass. The tile transfers its mandala relief to the bottom of the fused piece.
Can I fuse frit on the texture tile?
Yes. Load the primed tile surface with frit and fire. The mandala pattern shows through the fused frit and becomes part of the finished piece.
What COE glass can I use?
Any COE. Ceramic kiln tiles are COE agnostic, so the same tile works with COE96, COE90, or other fusible glass. Match your firing schedule to the glass you are using.
Specifications
- SKU: 158186
- Manufacturer: Creative Paradise (CPI.GX17)
- Pattern: Mandala
- Tile size: 7 inches L x 7 inches W
- Diagonal: 10 inches
- Material: ceramic kiln texture tile, reusable
- Glass: any COE (COE agnostic)
Working Notes
These are guidelines, not guarantees. Every kiln fires a little differently, so test a small run first when the result matters and follow a fusing schedule suited to your glass and kiln.
- Prime the tile surface with a boron nitride mold primer such as ZYP Boron Nitride Mold Primer, or a kiln wash such as Hotline Primo Primer, following the separator manufacturer's instructions to apply and cure it fully before placing glass on the tile.
- Place your glass sheet or layers on the prepared tile. Fire to fuse and the tile transfers its mandala texture to the underside of the glass.
- To use with frit, load the primed tile surface with frit and fire. The mandala relief becomes visible through the fused frit layer.
- The tile is COE agnostic. Use a fusing schedule matched to your glass, adjusting the final anneal soak for your COE.
- Let the kiln cool fully before removing the fused glass. Re coat the tile with separator as needed between firings.
- The Slide Hi Temp brand separator is not recommended with these tiles.
Creative Paradise Suggested Firing Schedule
This is a suggested COE96 starting schedule, not a guarantee. Every kiln fires differently. Test a small run and adjust the schedule for your glass and kiln.
Full Fuse (COE96, two full layers):
| Segment |
Rate |
Temp (F) |
Hold |
| 1 |
275 |
1150 |
60 |
| 2 |
50 |
1300 |
20 |
| 3 |
350 |
1465 |
05 |
| 4 |
9999 |
950* |
60 |
*Segment 4 is the anneal soak at 950 F for COE96. If using COE90, adjust this temperature to 900 F.
Helpful downloads: Mandala Textured Fusing Tile Tutorial (PDF)
Description updated: July 6, 2026
Spot an error or have feedback on this description? Report it here.