Small Cone Former Flower Mold

The Small Cone Former Flower Mold from Creative Paradise is a ceramic slumping form designed to shape glass into flowers with deep centers, such as petunias and small lilies, with organic ruffled petals. To use it, a pre-cut or pre-fused glass blank is draped over the cone form and fired so the glass softens and settles around the shape by gravity.

The mold measures 3.5 inches in diameter and 3.5 inches tall. Like all ceramic slumping molds, it is COE agnostic and reusable across many firings when prepped and cared for properly.

What does the Small Cone Former Flower Mold make?
It shapes glass into flowers with deep centers, such as petunias and small lilies, with organic ruffled petals. The cone draws the glass downward as it softens, producing a flower form.

How do I use a cone former mold?
Start with a pre-cut or pre-fused glass blank sized to your intended flower. Set it centered over the cone form, then fire at a slumping temperature suited to your glass so gravity eases the blank down around the cone into a flower shape.

What COE glass can I use with this mold?
Any COE. Ceramic slumping molds are COE agnostic, so the same mold works with COE96, COE90, or other fusible glass. Match your slumping schedule to the glass you are using.

How do I prep the mold before slumping?
Coat the mold surface with a kiln shelf primer such as a boron nitride spray or a kiln wash such as Hotline Primo Primer, and let it dry completely before placing your glass blank so the formed piece releases cleanly.

Specifications

• SKU: 7352
• Manufacturer: Creative Paradise (CPI.GM49)
• Makes: flowers with deep centers, such as petunias and small lilies
• Mold size: 3.5 inches diameter x 3.5 inches tall
• Material: ceramic kiln slumping mold, reusable
• Glass: any COE (COE agnostic)

Working Notes

These are guidelines, not guarantees. Every kiln fires a little differently, so test a small run first when the result matters and follow a slumping schedule suited to your glass and kiln.

• Prime the mold surface with a boron nitride mold primer such as ZYP Boron Nitride Mold Primer, or a kiln wash, and let it dry completely before placing your glass blank.
• This is a draping and slumping form, not a casting mold. Place a pre-cut or pre-fused glass blank centered over the cone and fire at a slumping temperature so the glass softens and takes the flower shape.
• The mold is COE agnostic. Use a slumping schedule matched to your glass, adjusting the final anneal soak for your COE.
• Let the kiln cool fully before removing the formed piece. Re coat the mold with primer as needed between firings.

Description updated: July 6, 2026

Spot an error or have feedback on this description? Report it here.