Wave Soap Dish Slumping Mold

The Wave Soap Dish slumping mold from Creative Paradise shapes a single glass soap dish with a wave texture across the surface. To use it, a pre-cut glass sheet is placed over the prepared ceramic form and fired so the glass softens and drapes into the dish shape by gravity. The mold footprint is 6 inches long by 4 inches wide by 1 inch tall, with a diagonal of 7 inches.

Like all ceramic slumping molds, this one is COE agnostic. Use it with COE96, COE90, or other compatible fusible glass, matching your firing schedule to the glass you are using. The mold is reusable across many firings when prepped and cared for properly.

What does the Wave Soap Dish mold make?
It shapes a single glass soap dish with a wave texture, formed from a 6 inch by 4 inch mold. The finished dish works well as a functional glass accessory or decorative piece.

How do I use this slumping mold?
Place a pre-cut sheet of fusible glass over the prepared mold surface and fire using a slumping schedule. As the kiln heats, the glass softens and sags into the wave dish shape by gravity.

What COE glass can I use in this mold?
Any COE. Ceramic slumping molds are COE agnostic, so the same mold works with COE96, COE90, or other fusible glass. Match your firing schedule to the glass you are using.

How do I prep the mold before slumping?
Coat the mold surface with a kiln shelf primer such as a boron nitride spray (for example ZYP) or a kiln wash such as Hotline Primo Primer, and let it dry completely before placing your glass. Re coat as needed between firings.

Specifications

• SKU: 163987
• Manufacturer: Creative Paradise (CPI.GM222)
• Makes: 1 wave-textured soap dish
• Mold size: 6 inches L x 4 inches W x 1 inch T
• Diagonal: 7 inches
• Material: ceramic kiln slumping mold, reusable
• Glass: any COE (COE agnostic)

Working Notes

These are guidelines, not guarantees. Every kiln fires a little differently, so test a small run first when the result matters and follow a slumping schedule suited to your glass and kiln.

• Prime the mold surface with a boron nitride mold primer such as ZYP Boron Nitride Mold Primer, or a kiln wash, and let it dry completely before placing your glass so the glass does not stick.
• Cut your glass sheet to fit the mold footprint before firing. A single layer of glass is typical for slumping.
• The mold is COE agnostic. Use a slumping schedule matched to your glass, adjusting the final anneal soak for your COE.
• Let the kiln cool fully before removing the dish. Re coat the mold with primer as needed between firings.
• The Slide Hi Temp brand separator is not recommended with these molds.

Creative Paradise Suggested Firing Schedule

This is a suggested COE96 starting schedule, not a guarantee. Every kiln fires differently. Test a small run and adjust the schedule for your glass and kiln.

One-and-Done (COE96): for a single layer of COE96 glass with frit.

*Segment 4 is the anneal soak at 950 F for COE96. If using COE90, adjust this temperature to 900 F.

Description updated: July 6, 2026

Spot an error or have feedback on this description? Report it here.