Weave Slumping Mold

The Weave Slumping Mold from Creative Paradise creates a woven surface texture on a flat glass blank in a single firing. A pre-cut sheet or fused blank is placed over the form and heated until the glass softens and settles onto the textured surface, picking up the weave pattern as it slumps. At 13 inches by 7 inches, the mold is well suited to decorative platters, serving trays, and wall panels.

The diagonal measures 14.75 inches. Like all ceramic slumping molds, it is COE agnostic and reusable across many firings when prepped and cared for properly.

What does the Weave Slumping Mold make?
It slumps a flat glass blank onto a woven surface, transferring the weave pattern to the underside of the piece and producing a textured, basket-weave look on the finished glass.

What size glass blank do I need?
Cut a blank to fit within the 13 inch by 7 inch mold footprint. Trim your sheet so it sits comfortably over the form without overhang that would cause uneven slumping.

What COE glass can I use?
Any COE. Ceramic slumping molds are COE agnostic, so the same mold works with COE96, COE90, or other fusible glass. Match your firing schedule to the glass you are using.

How do I prep the mold before slumping?
Coat the mold surface with a kiln shelf primer such as a boron nitride spray (for example ZYP) or a kiln wash such as Hotline Primo Primer, and let it dry completely before placing your glass blank on the form.

Specifications

• SKU: 10801
• Manufacturer: Creative Paradise (CPI.GM114)
• Makes: slumped glass with woven surface texture
• Mold size: 13 inches L x 7 inches W
• Diagonal: 14.75 inches
• Material: ceramic slumping mold, reusable
• Glass: any COE (COE agnostic)

Working Notes

These are guidelines, not guarantees. Every kiln fires a little differently, so test a small run first when the result matters and follow a slumping schedule suited to your glass and kiln.

• Prime the mold surface with a boron nitride mold primer such as ZYP Boron Nitride Mold Primer, or a kiln wash, and let it dry completely before placing your glass blank on the form.
• Place a pre-cut or fused glass blank over the form. Cut your blank to fit within the 13 inch by 7 inch footprint so the glass slumps evenly.
• The mold is COE agnostic. Use a slumping schedule matched to your glass, adjusting the final anneal soak for your COE.
• Let the kiln cool fully before removing the slumped piece. Re coat the mold with primer as needed between firings.
• The Slide Hi Temp brand separator is not recommended with these molds.

Creative Paradise Suggested Firing Schedule

This is a suggested COE96 starting schedule, not a guarantee. Every kiln fires differently. Test a small run and adjust the schedule for your glass and kiln.

Slump (COE96):

*Segment 4 is the anneal soak at 950 F for COE96. If using COE90, adjust this temperature to 900 F.

Helpful downloads: Woven Glass Tutorial (PDF)

Description updated: July 6, 2026

Spot an error or have feedback on this description? Report it here.