Twisted Cane Murrini Stick Canary Yellow and French Vanilla COE90

This listing is for a single twisted cane murrini stick in canary yellow and French vanilla. Viewed end on, the cross-section shows a canary yellow core, round on some sticks and a softened square on others, framed by a thin French vanilla white ring and surrounded by more bright yellow under a clear outer layer. The twist gives the pattern a gentle spiral along the stick, so slices cut at a slight angle pick up a hint of rotation. The palette pairs vivid yellow against quiet cream.

Cut thin cross-section slices from the stick and each one carries the same ringed face, since the pattern runs the full length of the cane. Place individual slices on the surface of a COE90 fused glass piece and fire them in as decorative accents. They suit jewelry pendants, plates, dishes, suncatchers, and ornaments, adding a small circle of yellow and cream wherever you set one down.

What does the cross-section pattern look like?
A ringed, bulls-eye style pattern in warm yellow and cream, with a canary yellow center wrapped by a thin French vanilla ring, more yellow, and a clear outer skin.

What COE glass do I need to use with this cane?
This cane is COE90. Combine it only with glass of the same COE. Mixing incompatible coefficients of expansion can cause cracking or delamination as the glass cools in the kiln.

How do I cut slices and use them in a fused glass project?
Cut thin cross-section slices with mosaic nippers or a wet tile saw, then place individual slices on the surface of your prepared COE90 base glass and fire. The same ring pattern appears on the face of every cut, giving you consistent results along the whole stick.

How long is the stick and how many slices will I get?
The stick is approximately 9 inches long. The number of slices depends on how thick you cut them: thinner slices yield more pieces and sit flatter when fused, while thicker cuts keep more height in a tack fuse.

Specifications

• SKU: 170555
• COE: COE90
• Sold as: single cane stick
• Stick length: approximately 9 inches
• Pattern: rings of canary yellow and French vanilla with a clear outer layer; center round or softened square, varying by stick

Working Notes

The temperature you reach in the kiln changes how slices from this cane look in the finished piece. A full fuse melts each slice flat and flush with the surface of your base glass, so the ring pattern sits smooth and level. A tack fuse stops short of full melt and leaves the slice raised above the surface in a low dome, preserving more of the three-dimensional ring profile.

Always test a small sample piece before committing to a full project run. Match your firing schedule to your specific kiln, your base glass, and the thickness of your slices. No single schedule works for all kilns and all glass combinations.

Description updated: July 6, 2026

Spot an error or have feedback on this description? Report it here.